Thomas Willard
03-24-05, 10:02 AM
As the owner of a Denon 2803, I recently was looking for outputs to hook up my new headphone amp to. I finally settled on using the zone 2 outputs, but found that there did not seem to be any output from the front left and right pre outs. There wasn't any output either from the zone 2 until I went to the OSD and set the output to the 0 db setting. Is there a similar setting for the pre outs? I don't remember finding anything in the manual concerning their use.
The LFE output seems to work fine and up until now that was the only one I was using. And of course the manual does refer to the LFE setting as it does the zone 2 setting.
The LFE output seems to work fine and up until now that was the only one I was using. And of course the manual does refer to the LFE setting as it does the zone 2 setting.